infael Posted November 22, 2005 Report Share Posted November 22, 2005 My new vid card is just a little too long. One of my IDE channels is in the way. It's just the corner so if I can remove it, it'll fit. The corner already has a hole in it, punched by the factory. There are no cirucuits or anything close by. I'd just be removing that hole. I've a picture but I apparently need a hosting site to post it here. What's a good way to remove the corner? I was thinking a Dremel might do it... TIA Link to comment Share on other sites More sharing options...
infael Posted November 22, 2005 Author Report Share Posted November 22, 2005 https://www.leadtek.com/3d_graphic/winfast_...0_gttdh_1.html# If you click on the picture of the vid card, you'll get an enlarged pix. The punched hole at the lower right corner is what I need to remove. Link to comment Share on other sites More sharing options...
Slaughter Posted November 22, 2005 Report Share Posted November 22, 2005 As long as there's no "metal" there, you're just removing plastic as far as I can understand. Then again, I don't know too much about it, so you should wait for advice from someone than knows more than I do. Link to comment Share on other sites More sharing options...
Kret Posted November 22, 2005 Report Share Posted November 22, 2005 I wouldn't even dare to try that, I would rather get a new mobo, a new hard drive and reinstall everything rather than to risk damaging the card by accident. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now